Wearing the Galaxy Fit

Putting on the Galaxy Fit

Open the buckle and place the band around your wrist. Insert the pin into the hole. Make sure to fasten the watch in the hole one further out than you normally would not to feel any discomfort as the band can be inadvertently tightened if the end of the band is pulled inward.

Do not bend the band excessively. Doing so may damage the Galaxy Fit.

To measure your heart rate more accurately with the Galaxy Fit, wear the Galaxy Fit firmly around your lower arm just above the wrist. Refer to Wearing the Galaxy Fit correctly for more information.

Taking off the Galaxy Fit

When taking off the Galaxy Fitⓔ, pull down on the buckle and pull it out as shown in the figure below.

Replacing the band

Detach the band from the Galaxy Fit to replace it with a new one.

1. While holding the Galaxy Fit, gently pull on one of the band connections to lift it up.

Be sure to pull out the band close to the screen. Pulling the end of the band may damage the band.

Keep the Galaxy Fit stable and remove the band. Otherwise, the Galaxy Fit may be damaged during band replacement.

2. Insert one side of the band into one side of the Galaxy Fit and gently pull out the opposite side of the band connection and then fit it to the other side of the Galaxy Fit.